Mooko's Drone Ambient Setup: 4P2K and Empress Zoia
Share

Mooko, a musician in France, sent us a photo of the setup used for making drone ambient music, and kindly let us share it here.
The 4P2K sits right on top of an Empress Zoia. Its four knobs and two keys all control Zoia parameters over CC. Drone music changes slowly, so knobs you can turn a little at a time are a good fit for things like filter and feedback.
Clock from Ableton Live
Ableton Live on the computer sets the tempo. The 4P2K is connected to the computer over USB, and with TRS MIDI THRU turned on, the MIDI clock and Start/Stop from Live go out of the 4P2K's TRS output to the Zoia. No separate MIDI interface is needed. Mooko also tried the same connection with a monome norns, and it worked well there too. The setup steps are in Sync Your Gear to Your DAW Through the Controller.
A tip for keys that send CC
The Zoia uses the CC value it receives as the parameter value. So if you set a key's On value to 127, each press turns a switch on or off. If that value is 0, pressing the key changes nothing. The config page now warns you about this.
Listen
You can hear Mooko's music on YouTube: MoOkO on YouTube
Thank you, Mooko, for the photo and for letting us share your setup.